How to Change LEDs on Roccat Ryos

The basics should be the same on most mechanical keyboards. You can damage your keyboard if you don't know what you are doing

Steps

  1. Image titled Change LEDs on Roccat Ryos Step 1
    1
    Opening up the keyboard
    • There are 14 total screws on the back of the keyboard.
    • 6 of them can be seen right away, while the rest isn't.
    • There are 3 screws behind the thin rubber patch, one behind each thick one, and one behind the label.
    • After unscrew all of them, you should now be able to just lift the cover off.
  2. Image titled Change LEDs on Roccat Ryos Step 2
    2
    Getting the keyboard's...board? out
    • There are 6 screws in this step, one of them is tying the center piece to ground cable.
    • After unscrew all of them and disconnecting the data cable, lift the center piece up and flip it over. (You can disconnect the thumb key if you like)
  3. Image titled Change LEDs on Roccat Ryos Step 3
    3
    Swapping out the dead leds
    • Find the position of your dead leds, then desolder them using soldering pump. Led should just fall off right away
    • Before putting the new led in, make sure the polarity is correct (use multimeter or just touch the terminal with led pins).
    • Put the led in the slot and solder them (make sure the gap between led and button is tight, you can just put a piece of tissue paper under the board to push the led towards the board)
  4. Image titled Change LEDs on Roccat Ryos Step 4
    4
    Thumb keys
    • Sorry, no photo, but this one is more straight forward, the only hard part is the size.
    • Desolder old ones, put the new one in. You can just melt both solder simultaneously then throw the led on it. Also, don't forget the polarity first!
  5. Image titled Change LEDs on Roccat Ryos Step 5
    5
    Putting stuff back
    • Should be simple, just reverse everything you've done, don't forget to connect the ground wire.

Things You'll Need

  • Soldering Iron (Decent one would be nice)
  • Desoldering pump
  • Solder (standard one with flux core will do)
  • 3mm flangeless leds with color of your pick, around 3-7 cent each. You can get some from here

If you want to change the led of the thumb-key

  • Soldering Stand (To hold the PCB)
  • Really really small smd led, 0201 or smaller, also with color of your choice. Should not cost more than 30 cent each.

Article Info

Categories: Input Devices | Hardware Maintenance and Repair